Actions

MD07012 - 12 V / 2.8 A Step-Down Converter Module with MP4315

From Modig.pl Wiki

Revision as of 10:46, 18 October 2026 by Grzegorzbecker (talk | contribs) (→‎Standard Equipment)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Description

MD07012 - 12 V / 2.8 A Step-Down Converter Module with MP4315

The Modig MD07012 is a compact switching regulator module with a 12 V output. Despite its small dimensions (21x18 mm), it delivers an output current of up to 2.8 A. It features built-in protection against reverse input voltage polarity, overloads, and overtemperature.


Key Features and Specifications

  • Wide input voltage range: 12…42 V
  • Maximum continuous output current: 2 A
  • Maximum peak output current: 2.8 A (operation duration depends on thermal conditions)
  • Output voltage: 12 V ± 5%
  • Input voltage must be at least 0.5 V higher than the target output voltage
  • MP4315 switching regulator
  • DC/DC converter switching frequency: approx. 700 kHz
  • Efficiency: over 90% at 2.5 A load
  • Overload and overtemperature protection
  • EN input to switch the regulator into standby mode (current consumption below 0.5 mA)
  • PG output indicating proper converter operation
  • Compact dimensions: 21x18 mm

Standard Equipment

Code Description
MD07012
  • Assembled and tested module



Connection Diagram

Along the edges of the module PCB, there are through-hole pads arranged on a 2.54 mm grid for the input (VI), output (VO), and ground (GND). Pin headers or wires can be soldered to them, allowing the module to be optimally tailored to the target application.


The EN input is pulled up to the positive supply rail (VI), enabling the regulator immediately upon power-up (the EN input can remain unconnected). Connecting the GND ground to this input will disable the regulator, resulting in zero output voltage and negligible current consumption (approx. 0.5 mA).


The PG (Power Good Indicator) output signals proper converter operation, at which point its voltage is approximately 5 V. If the voltage on the PG output drops to around 0 V, it indicates improper converter operation and/or a lack of proper output voltage.




Dimensions

The exact dimensions of the module are 20.3 × 17.8 mm. Along the edges of the module PCB, there are through-hole pads arranged on a 2.54 mm grid. The board also features 2 mounting holes with a diameter of 2 mm.



Links